
Product Overview
Zhimeitang MGS200 is a non-ionic water-soluble cellulose ether made from natural cellulose materials with a viscosity of 18,000 cps to 22,000 cps .
Main ingredients	HPMC
additive	none

Technical requirements

Appearance	White powder, odorless and tasteless
Methoxy content	19.0～24.0%
Hydroxypropoxy content	4.0～12.0%
Viscosity	18000 ～22000cps ( 2% aqueous solution, 20 ± 0.2 ℃, Brookfield RV viscometer, 20rpm )
Loss on drying	≤8.0%
Ash on ignition	≤2.5%
pH	5.0 ～9.5 ( 1% aqueous solution)
Gel temperature	≥70℃
Fineness	80 mesh pass rate ≥ 90%

Application

Water-retaining thickener for gypsum mortar and putty

Main application areas

-Especially suitable for light and heavy plastering gypsum, as well as putty, gypsum and tile adhesive that require non-stick knives.

Main performance

- Odorless and tasteless
-Low ash content
-High gel temperature
-High water retention
- Medium to low viscosity
-Anti -salting out

Mixing of cellulose ether

Zhimeitang MGS200 can be mixed with other dry materials in commercially available mixing equipment to produce powdered products, but the mixture must be fully mixed. When mixing a powdered product, typically add the required amount of mixing water to a suitable container and then add the powdered dry mix while stirring. Excessive stirring can introduce excess air bubbles. Before use, allow the mixture to rest for a short while. Depending on the properties of other additives, this resting time should be approximately 1 to 5 minutes.

Packaging and storage

Standard packaging : 25kg paper bag lined with polyethylene film bag
Other types of packaging are also available upon special request

As a general rule, it is recommended that the Zhimeitang MGS200 be stored in a cool, dry, and well-ventilated place indoors and used within 6 months. If the packaging bag is stacked under pressure, damaged, or opened for too long, it may cause caking.

Quality, safety and environmental protection

This product is not a hazardous chemical. All users are advised to read the product safety instructions carefully.

Product Liability

The above information and suggestions are based on our experience and are for reference only. They do not replace the customer's own experiments. Since Zhimeitang cannot control the transportation, storage, handling, and use conditions of the products after they are sold, any quality accidents or financial disputes caused by improper use cannot be attributed to the advice we provide. In any application, the customer shall assume the obligation to comply with the intellectual property rights of third parties.

Technical information may not be provided to third parties without our consent.